2w pa power amplifier
2w PA Power Amplifier 185Mhz-215Mhz 12V 75ohms 6dbm input 33dbm output for DVB-T COFDM TX Transmitter transmission
PA hwj chim amplifier COFDM
Buyers requirement
- 2W power amplifier
- Frequency 185Mhz~215Mhz
- Input 75ohms 6dbm
- Output 33dbm
- 12V Fais fab Input
The pa power amplifier module realizes the power amplification output of the RF signal. When the input voltage is 12V, connect to COFDM modulation board, the output power can be up to 2W (+33dBm)
nta
- Working frequency band: 185MHz~215MHz
- nce: 45dB
- Power Amplifier out: +33dBm (PAR=9.9dB)
- ACPR: < -36dBc
- IP3: +49dBm
- Noise Figure: 6dB
- Kev muab cov voltage: 12V, output 2W (+33dBm) transmit power, power consumption is about 8.7W.
- RF interface: SMA male thread hole
specification
Test items | Technical Indicators | Cov lus ceeb toom |
ntau zaus (MHz) | 200±15 | |
SPAN (MHz) | 8 | |
Output power (W) | ≥2 | |
P1dB Output power (W) | 10 | |
nce (dB) | 28±1.0 | |
Pass Band Ripple | ≤1.0dB p-p | |
Input zog (dBm) | 6±1.0 | |
ACPR (dBc) | ≤-35@8M@2W | |
Fais fab mov voltage | +12V~+17V Vdc | |
Group Delay | <1us | |
Ua haujlwm tam sim no | ≤1.2A | |
kub ntau | -20~+70℃ | |
Radiofrequency joint | SMA-50KFD | |
Module size (hli) | 81x48x14mm | without connectors |
Module weight | 89g | |
impedance | 50 ohm |
Installation hole diameter size:
4 installation holes are left with 4*3.5mm through holes for installation.
Xyuas
Muaj cov kev xyuas tsis tau.