COFDM Wireless Video Receiver HDMI CVBS output

COFDM Wireless Video Receiver HDMI CVBS output mini modulator module long-distance FPV UAV Transmission UART config Recorder

specification

Work for COFDM-907T

HD digital wireless video transmission receiver COFDM-907R
Built-in Decoder board and COFDM dual-antenna receiving demodulation module, the whole machine adopts aluminum alloy casing, high receiving sensitivity, low decoding display delay, high-definition video output stable and clear.

nta

1. Dual Antenna reception
2. Support working frequency range: 160MHz~930MHz, the center working frequency can be configured;
3. Wireless bandwidth is configurable;
4. The sensitivity of dual antenna reception -100±1dbm (QPSK 8MHz);
5. Wireless receiving status information (such as received signal strength, air interface rate, cov ntaub ntawv tus nqi, working frequency, wireless bandwidth, lwm.) can be superimposed/not displayed on the video screen through the OSD switch button, or output to the serial port (customized) ;
6. Low-latency H264 video decoding, support 1080P@60 decoding playback;
7. Audio and video output (HDMI, CVBS, USB port simultaneous output):
   1. HDMI Type-A port audio and video output
   2. CVBS (Lotus Head) AV audio and video output
   3. Output video stream to the phone/tablet decoding display via USB port
8. Support video receiving and decrypting function (matching with video encryption at the transmitting end);
9. Support TF card or USB disk video recording;
10. Provide one-way single-direction transparent data transmission serial port;
11. Provide parameters to configure the serial port for working settings (such as center working frequency, wireless bandwidth, receiving decryption password);
12. Fais fab mov: 6~15V, working power consumption is 230mA@12V.
13. Machine size: 115x90x34mm
14. Machine weight: 243 grams

connector:

1. Power In: 12~ 24V
2. RJ45：preset for future
3. HDMI Out: A type HDMI carrier, high-definition audio and video output interface
4. CVBS AV tawm analog video output interface
5. RF ANT In wireless signal input antenna interface, SMA external threaded inner hole
6. UART : TX RX GND to connect the PC for frequency adjust
7. USB interface:
   1. Recording video can be connected to an external USB flash drive or USB hard disk
   2. Upgrade for new firmware
8. pib: Auto-Search new channel
9. Info: Show current channel information, for example, zaus, bandwidth, thiab lwm yam
10. REC: Record current channel to the USB stick
11. Stop: Stop to record
12. Channel Switch: Switch channel loop from 503Mhz, 509Mhz, 515Mhz, and 521Mhz.
13. OK: confirmation

loj

112mm × 67.5mm × 22mm

RF Performance Test

Operating Center Frequency 470MHz, Fais fab Amplifier: 1W

Operating Center Frequency 700MHz, Fais fab Amplifier: 1W

Optional Remote Control