DVB-T2 Module

DVB-T2 Module

1. Introduction

1.1 . Egenskaper
● Fully compliant with DVB-T2 specification
● Perfect performance for mobile digital TV
● High-performance RF tuner

• UHF : 474.000MHz ~ 858.000MHz
  ● Communication interface
• IR and Uart
  ● Video output
• CVBS
• HDMI
• YPbPr
  ● Audio output
• Analog 2 Channel Stereo
  ● Update interface
• USB
  ● Voltage input : +3.3V , +1.8V
  ● Dimension (LWH): 40 * 38*4.8mm
  1.2 . applikasjoner
  ● Digital TV on Mobile for DVB-T/T2
  ● Personal Navigation Devices
  ● Car A/V, DVDP and Multimedia Player
  ● Test and Measurement equipment
  ● Portable and Handheld Devices

1.3 Block Diagram
Full Module Block Diagram

2 . PIN Descriptions
2 .1 Dimension Information
2.1.1 Pin Dimension(Top View)

2.1.2 Height Dimension

2.2 . Pin descriptions
CON1:1.27mm pitch connector(21tapp)

2.3.Connector Dimension
2.3.1 CON1&CON2

2.3.2 Antenna Connector

3 . Application Schematic
3.1 CVBS output

3.2 Audio amplifier

3.3 Module Reset (Active High)

4 . IR Control Interface
4.1. Transmission Format
The transmission format consists of the transmission of a leader code, 16-bit custom codes
(Custom Code, Custom Code’), and 16-bit data codes (Data Code, Data Code) simultaneously, as
shown in Figure 4-1. Data Code is the inverted code of Data Code. The leader code consists of
a 9-ms carrier waveform and a 4.5-ms OFF waveform and is used as a leader for the ensuing
code to facilitate reception detection. Codes use the PPM (Pulse Position Modulation) method,
and the signals “1” and “0” are fixed by the interval between pulses.

4.2. IR command list
Custom code: 0x00FF

5 . UART Control Interface
5.1. Uart for data
Baudhastighet: 115200/57600/38400/19200/9600bps
Dataformat: 0x01 + 0x88 + 0x00 + 0x01 + data + 0x03 + 0x00 + 0x00

5.2. Uart for X/Y coordinate
Dataformat: 0x01 + 0x88 + 0x02 + 0x02 + Byte1 + Byte2 + 0x03 + 0x00 + 0x00
Byte1 = Touch Location X; Byte2 = Touch Location Y;
Merk: The full screen X/Y coordinate range is 0~255 ;The screen
left top corner coordinate is (0,0).

6. Electrical specification
■ General Specifications

■ Operation Conditions

■ Operation Conditions