2w PA Power Amplifier 185Mhz-215Mhz 12V 75ohms 6dbm input 33dbm output
2w pa power amplifier
2w PA Power Amplifier 185Mhz-215Mhz 12V 75ohms 6dbm input 33dbm output for DVB-T COFDM TX Transmitter transmission
PA power amplifier COFDM
Buyers requirement
- 2W power amplifier
- Frequency 185Mhz~215Mhz
- Input 75ohms 6dbm
- Output 33dbm
- 12Mana'o Tauturu i te Haapiiraa
The pa power amplifier module realizes the power amplification output of the RF signal. When the input voltage is 12V, connect to COFDM modulation board, the output power can be up to 2W (+33dBm)
Mau raveʻa
- Working frequency band: 185MHz~215MHz
- Farii: 45DB
- Power Amplifier out: +33dBm (PAR=9.9dB)
- ACPR: < -36dBc
- IP3: +49dBm
- Noise Figure: 6DB
- Te huru o te û o te taata: 12IRAVA, output 2W (+33dBm) transmit power, power consumption is about 8.7W.
- RF interface: SMA male thread hole
Specification
| Test items | Technical Indicators | Mau mana'o |
| Pinepineraa te (MHz) | 200±15 | |
| SPAN (MHz) | 8 | |
| Output power (W) | ≥2 | |
| P1DB Output power (W) | 10 | |
| Farii (DB) | 28±1.0 | |
| Pass Band Ripple | ≤1.0dB p-p | |
| Te mana no te hamaniraa i te tamarii (dBm) | 6±1.0 | |
| ACPR (dBc) | ≤-35@8M@2W | |
| Power supply voltage | +12V～+17V Vdc | |
| Group Delay | ＜1us | |
| Te raveraa i te ohipa i teie nei | ≤1.2A | |
| Temperature range | -20～+70℃ | |
| Radiofrequency joint | SMA-50KFD | |
| Module size (mm) | 81x48x14mm | without connectors |
| Module weight | 89g | |
| Impedance | 50 ohm |
Installation hole diameter size:
4 installation holes are left with 4*3.5mm through holes for installation.
Hiopoa
Aita e hiopoa.